Loading ...
Loading ...
Loading ...
Yournew tractor has been assembled at the factorywithexception of those partsleft
unassembled for shippingpurposes,To ensure safe and proper operationofyour
tractorall partsand hardware you assemble mustbe tightened securely.Use the
correcttools as necessary to insure proper tightness,Review the videocassette before
you begin.
TOOLS REQUIRED FOR
ASSEMBLY
A socket wrench set willmake assembly
easier. Standard wrench sizes you need
ere listed below,
(1) 9Ire"wrench (1) Pliers
(1) 1/2"wrench (1) Utilityknife
(1) Tire pressure
gauge
When dght or left hand is mentioned in
this manual, it means, from your point of
view, when you are in the operating
position(seated behind the steering
wheel),
TO REMOVE TRACTOR FROM
CARTON
UPACK CARTON
1. Remove all accessible loose parts
and partscartons from carton.
2. Cut, from top tobottom, along lines
on all four comers of_don_ and lay
panels flat, S
3. Check forany additionalloose parts
or cartonsand remove.
/
BEFORE REMOVING TRACTOR
FROM SKID /
ATTACH STEE_NG WHEEL
ASSEMBLE EXTENSION SHAFT AND
BOOT
1. Slide extension shaft ontolower
steeringshaft, Align mountingholes
in extension and lower shaftsand
install5/16 hex boltand Iocknut,
Tighten securely.
2. Place tabs of steering bootovertab
slots in dash and push down to
secure.
INSTALL STEERING WHEEL
3, Position front wheelsof the tractorso
they are pointing straight forward,
4. Remove steering wheel adapter from
steering wheel and slide adapter
onto steering shaft extension.
5. Position steering wheel so cross bars
are horizontal (left to right) and slide
inside boot and onto adapter.
6. Assemble large flat washer, 3/8 Dock
washer, 3/8 hex bolt and tighten
securely,
7. Snap steering wheel insert into center
of steeringwheel.
8. Remove protective materialsfrom
tractor hoodand grill.
IMPORTANT. CHECK FOR AND
REMOVE ANY STAPLES IN SKID THAT
MAY PUNCTURE TIRES WHERE
TRACTOR IS TO ROLL OFF SKID.
SteeringWheel
_ Insert
SteeringWheel {.;_. Tabs
SteeringBoot_
Adapter_ Extension
_// Shalt
Locknut L-_'----- 5/16Hsx
Lower ,. --_.:.!.
Steering_ _ "::_"".
"_L'" <;
HOW TO .SETUP YOUR TRACTOR
CHECK BATTERY
1. Lift seat pan to raised positionand
open battery box door,
NOTE: ifthis batteryisput into sewice
after monthand year indicatedon label
(label located between terminals) charge
batteryfor minimumof one hourat 6-10
ampe. (See "BATTERY" in Maintenance
section of this manual forcharging
instructions),
8
Loading ...
Loading ...
Loading ...