Loading ...
Loading ...
Loading ...
DADOING
Instructions for operating the Dado Head are
contained in boo _let furnished with the Dado Head.
The Recommended Dado Head is listed under
Recommended Accessories in this manual.
The arbor on the saw, is only long enough so that
the widest cut that can be made is 13/16" wide.
It is not necessary to install the outside loose collar
before screwing on the arbor nut. Make sure the
arbor nut is tig ht.
ALWAYS USE DADO INSERT LISTED UNDER
RECOMMENDED ACCESSORIES.
When using the dado head it will be necessary to
remove the Blade Guard and Spreader. Use Miter
Gage and follow same procedures ano Instructions
for C ross Cutting.
ALWAYS REPLACE THE BLADE, GUARD AND
SPREADER WHEN YOU ARE FINISHED
DADOING.
MOLDING CUTTING
Instructions for operating the Molding Head are
contained in a booklet furnished with the Molding
Head.
The recommended molding head is listed under
Recommended Accessories in this manual
Always use Molding Insert Listed Under
Recommended Accessories.
When using the molding head it will be necessaryto
remove the Blade Guard and Spreader. USE
o o
LOOSE :OLLA_
ARBOR _ SAW ARBOR
REMOVE SAWBLADE AND
INSTALL DADO HEAD
.J
BACK OF SAW
CAUTION. USE FEATHERBOARDS AND PUSH
STICKS, etc AS REQUIRED.
ALWAYS REPLACE THE BLADE GUARD AND
SPREADER WHEN YOU ARE FINISHED
MOLDING.
USING FEATHERBOARDS
Add 8 inch high flat facing board to the fence, the
full length of the fence.
Use featherboar.ds for all non "thru-sawing"
operations (when sawblade guard must be
removed). Featherboards are used to keep the work
in contact with the fence and table as shown, and to
stop kickbacks.
Mount featherboards to fence and table as shown,
so that leading edges of featherboards will support
workpiece until cut is complete, and the workpiece
has been pushed completely past the cutter
(sawblade, dado head molding head, etc.) with a
pushstick, as in ripping.
"C" CLAMPS
Before starting the operation (switch "OFF" and
cutter below table surface):
(a) Install featherboards so they exert pressure on
the work piece; be positive they are secure, and
(b) Make sure by trial that the featherboards will
stop a kickback if one should occur.
Featherboards are not employed during non thru-
sawing operations when using the miter gauge.
Replace the sawblade guard as soon as the non
thru-sawing ooeration is complete.
/
FEATHERBOARD
WORK SUPPORT
37
Loading ...
Loading ...
Loading ...