Loading ...
Loading ...
Loading ...
If you mount the saw on any other bench, make sure
that there is an opening in the top of the bench the
same size as the opening =nthe bottom of the saw so
that the sawdust can drop through. Recommended
working height is 33to 37 inches from the top of the
saw table to the floor.
16"3/4"
15,1
@
11,1/4
1
OPENING
7116" DIA, HOLES--_ --_
FRONT Ot: SAW
IMPORTANT -- Read Before Proceeding
Blade cannot be more than 2 inches above the table
top when tilting the sawblade to make bevel cuts or
adjustments, Lower blade to 2 inches or closer to
the table top to tilt the saw, Failure to do this may
result in damage to your saw.
INSTALLING HANDWHEELS
Line up FLAT SPOTS on shaft and handwheel, push
handwheel onto shaft. Install screw and Iockwashe r
to lOck handwheels on shaft.
ELEVATION
HANOWB
//
.OCKWASHER
/
/
10-32 x 3/4 IN.
PHILLIPS
HEAD SCREW
TILT HANDWHEEL
CHECKING TABLE INS ERT
1. Insert should be even with table top. Check as
shown. Loosen flat head screw that holds insert
and adjust the four set screws as necessary,
Tighten flat head screw. Do not _ighten screw to
the point where it deflects the insert.
3/32 IN
SETSCREW WRENCH
2. To remove insert.
A. Loosen Phillips Flat Head Screw.
B: Lift insert from front end, and pull toward front
of saw.
3. To replace insert:
Place insert into insert opening in table and push
toward rear of sawto engage spring clip and until
keyslot in insert w ! drop over screw T ghten
screw.
Do not tighten screw to the point where it will
deflect the insert.
/
Loading ...
Loading ...
Loading ...