Loading ...
Loading ...
Loading ...
NEVER OPERATETHE SAW WITHOUTTHE .......
PROPERINSERTIN PLACE. USE THE SAW
BLADEINSERTWHENSAWING, . . USE THE
COMBINATION DADO MOLDING INSERT (9-
22271) WHEN DADOING OR MOLDING.
<._> il/
SCREW
9 REMOVING AND INSTALLING SAWBLADE.
WARNING: TO AVOID INJURY DUE TO
ACCIDENTAL START, TURN SWITCH "OFF"
AND REMOVE PLUG FROM POWER
SOURCE OUTLET BEFORE REMOVING OR
iNSTALLiNG SAWBLADE.
A. Raise Blade Guard ... remove insert.
B. To REMOVE blade, place a block of wood
against front of blade. _. PULL arbor wrench
toward you to LOOSEN arbor nut.
BLADE GUARD NOT SHOWN FOR PICTURE CLARITY
BLOCK
:)R NUT
LOOSE
COLLAR
ARBOR
_@_ ARBOR NUT
TEETH POINTING TO .--,.-_
FRONT OF SAW t%...
10 EXACT-I-CUT
The "yellow" plastic disc imbedded in the table
in front of the sawblade, is provided fol
marking the location of the "sawcut" on the
workpiece.
A. Check disc ... if it is above table surface
place a piece of hardwood on top of it and ta!:
it down.
B. With blade 90 ° (square to table) cut off -"
piece of wood.
C. Pull miter gauge back until wood isover disc
Using very sharp pencil, mark a line on disc
D. With miter gauge in right hand g roove, follow
same procedure and mark another line or
disc.
E. These lines indicate the "path" of the cu'
//,_ (kerf) made by the sawblade.
..... ///_\ _'- F. When cutting the workpiece, line up mark or
_P,_I_#(_H ///////_L_ workpiece With line on disc.
i!fF y usethehold- ownc .mp(optionalaccessory
'BOR NU." i_J \\\' on the miter gauge for greater accuracy.
WOODSLOCK j// @
BLADE GUARD NOT SHOWN FOR PICTURE CLARITY _P_I_J__I_
C. TO TIGHTEN arbor nut, place a block of _____....--_j_r _
wood against rear of blade... PUSH wrench _-'-_--_I _I_JJdl_ _'_
away from you. _-_\iJ_ _ , _
When installin_l the blade . . . make sure the __.J_-_----_ _ _._._.,___ Z
teeth are
pointing
toward,he,rootofthesaw
. andthatthebladeandcollarsareclean and __ ,_/..-___-'P-
free from any burrs. " _ _ ('_-'_"-"-
The HOLLOW side of the collar must be _ y _ __L__.__ -___
against the blade. BLADE GUARD NOT SHOWN FOR PICTURE CLARITY
Always tighten the arbor nut securely.
F
NOTE: When using the Dado or Molding Head,
it s not necessary to install the loose collar.
To replace insert.
Place insert into insert opening in table and
push toward rear of saw to engage spring clip
and until keyslot in insert will drop over screw. _"
,¢
Do not tighten screw to the point where it will
deflect the insert.
Loading ...
Loading ...
Loading ...