Loading ...
Loading ...
Loading ...
WARNING: TO AVOID INJURY DUE TO
ACCIDENTAL START, TURN SWITCH "OFF" AND
REMOVE PLUG FROM POWER SOURCE OUTLET.
2. MAKE SURE THE BLADE IS ALL THE WAY UP
AND SQUARE WITH THE TABLE.
3. Position SPREADER SUPPORT on rod behind
the rip fence guide bar,
\
4. Assemble the 7/8 in. long setscrews, nuts. \
Iockwashers and washers to the SPREADER \
RIP FENCE
GUIDE BAR
/
BLADE SQUARE
WITH TABLE
SPREADER SUPPORT
POSITIONED ON ROD
BEHIND RIP FENCE
GUIDE BAR
SUPPORT BRACKET and slip the nuts into the
slot in the spreader support.
5, Locate spreader support and bracket on rod. 1/16
inch behind the fence guide bar.
6, Finger tighten ONLY THE HEX NUTS.
SPREADER SUPPORT_
..._-_-_BRACKET
VIEW LOOKING DOWN
FROM TOP
7. Lay a piece of flat straight wood and a square on
saw table and rotatethe SPREADER SUPPORT
until the bracket is aligned with square.
B.
24
Loading ...
Loading ...
Loading ...