Loading ...
Loading ...
Loading ...
RESAWING
RESAWING is known as ripping a piece of wood
through its thickness. Do not attempt to resaw
BOWED or WARPED material. NOTE: To RESAWa
piece of wood wider than 3-3/8 in... it will be
necessary to remove the blade guard ... and use the
AUXILIARY FENCE/WORK SUPPORT. (See "Work
Helpers").
Clamp it to the table so that the workpiece will
SLIDE EASILY but not TILT or MOVE SIDEWAYS
without BINDING between the two fences.
Do not clamp directly tc the bottom edge of the table
because the "swivel" of the clamp will not grip
properly. Place a small block of wood between the
bottom edge of the table and the "C" clamp.
WARNING: FOR YOUR OWN SAFETY...
I. DO NOT "BACK UP" (REVERSE FEEDING)
WHILE RESAWING BECAUSE THIS COULD
CAUSE A KICKBACK.
SMALL BLOCK
OF WOOD
/
2. MAKE FIRST PASS TO A DEPTH SLIGHTLY
LESS THAN ONE-HALF THE WIDTH OF THE
BOARD; KEEP SAME FACE OF BOARD
AGAINST FENCE FOR SECOND PASS AS THE
FIRST PASS.
3. iNSTALL BLADE GUARD IMMEDIATELY UPON
COMPLETION OF THE RESAWING
OPERATION.
CUTTING PANELS
When cutting panels (whenever fence is positioned
outside of table surface), ALWAYS use the
AUXILIARY FENCE/WORK SUPPORT.
1. Unlock fence and raise rear end.
2. Position AUXILIARY FENCE/WORK SUPPORT
as shown and attach it with two "C" clamps.
AUXILIARY FENCE/
WORK SUPPORT
RABBETING
RABBETING is known as cutting out a section of the
corner of a piece of material, across an end oralong
an edge.
To make a RABBET requires cuts which do not go
all the way through the material. Therefore the blade
1. Remove blade guard.
2. For rabbeting along an edge (long way of
workpiece) as shown, add facing to rip fence
approximately as high as the workpiece is wide.
Adjust rip fence and blade to required
AABDET
S 00"DF j
/
/
// RABBETING
ACROSS THE END
RABBETING ALONG
TNE EDGE
dimensions; then make first cut with board flat on
table as any rip (type) cut; makesecond cut with
workpiece On edge. Follow all precautions, safety
instructions, and operational instructions as for
piece to obtain thedesired width of cut. DO NOT
3. For rabbeting across an end, for workpiece 10- use the rip fence for rabbeting across the end,
1/2 and narrower make the rabbet cut w th the 4. INSTALL BLADE GUARD IMMEDIATELY UPON
board flat on the table. Using the miter gauge COMPLETION OFRABBETING OPERATION.
fitted with a facing follow the same procedures Rabbet cuts can be made in one pass of the work-
and instructions for cross cutting, making pieceoverthe cutterusing thedado head or molding
successive cuts across the width of the work- head.
Loading ...
Loading ...
Loading ...