Loading ...
Loading ...
Loading ...
Cleaning and maintenance
179
EN
What to do if...
The display is completely off:
• Check the mains power supply.
• Check that any circuit breakers upline of
the appliance supply line are in the
“ON” position.
The appliance does not heat up:
• Check whether “Show Room (for
showrooms only)“ or “Demo Mode (for
showrooms only)“ mode has been set
(for further details see section “Settings“).
The controls do not respond:
• Check whether “Controls lock“ mode
has been set (for further details see
section “Settings“).
After the (pyrolytic) automatic cleaning
cycle it is not possible to select a function:
• Verify whether the door lock has
deactivated. If it has not, the oven has a
safety device that does not allow
functions to be selected while the door
lock is active. This is because the
temperature inside the oven is still too
high to permit any type of cooking.
Error 4 appears on the display:
• The door lock has not properly attached
to the door. This might be because the
door was accidentally opened during
the door lock activation. Switch the oven
off and on again, waiting a few minutes
before selecting a new cleaning cycle.
If the door is opened during a fan assisted
function, the fan stops:
• This is not a fault. It is a normal operation
of the appliance, useful when cooking
foods in order to avoid excessive heat
escaping. When the door is closed, the
oven will return to normal operation.
Connectivity alarm (on some models only)
For further information, please refer to the
Connectivity Manual.
If the problem has not been
resolved or in the case of other
types of fault, contact your local
technical support centre.
If there are other error messages,
they will be indicated by Error XX:
Note down the error message,
function and set temperature and
contact your local technical
support centre.
Loading ...
Loading ...
Loading ...