Loading ...
Loading ...
Loading ...
Fig,Y
BEVELCROSSCUTTING(FIG.AA)
0°~45° BLADEBEVEL& 90 ° MITER ANGLE
This cutting operation is the same as crosscutting
except the blade is at bevel angle other than 0%
MAWARNING
Always work to the right side of the blade during this
type of cut. The miter gauge must be in the right side
groove because the bevel angle may cause the blade
guard to interfere with the cut if used on the left side
groove.
1. Adjust the blade (1) to the desired angle, and tighten
the blade bevel lock knob.
2. Tighten miter lock handle (3) at 90°.
3. Hold workpiece firmly against the face of the miter
gauge throughout the cutting operation.
Fig. AA
COMPOUND MITER CROSSCUTTING (FIG. BB}
00~45 ° BLADE BEVEL & 00~45° rvIITER ANGLE
This sawing operation is combining a miter angle with a
bevelangle_
[,_ WARNING ]
Always work to the right side of the blade during this
type of cut. The miter gauge must be in the right side
groove because the bevel angle may cause the blade
guard to interfere with the cut if used on the left side
groove.
1. Set the miter gauge (3) to the desired angle.
2. Place the miter gauge in the right side groove of
the table_
3. Set the blade (1) bevel to the desired bevel angle
and tighten the blade bevel lock knob.
4. Hold workpiece firmly against the face of the miter
gauge throughout the cutting operation.
Fig. BB
1 3
MITERING (FIG. CO) 00~45° MITER ANGLE
This sawing operation is the same as crosscutting
except the miter gauge is locked at an angle other
than 90°.
1. Set the blade (1) to 0° bevel angle and tighten the
blade bevel lock knob.
2. Set the miter gauge (3) at the desired miter angle
and lock in position by tightening the miter gauge
lockinghandle_
3. Hold the workpiece(2)firmlyagainstthefaceof the
mitergauge throughoutthecuttingoperation.
19
Loading ...
Loading ...
Loading ...