Loading ...
Loading ...
Loading ...
SAWMOUNTEDTOWORKSURFACE(FIG.B)
1. If the leg set will not be used, the saw mustbe
properlysecuredto a sturdyworkbenchusingthe
fourmountingholesat thebaseofthesaw.
2. Thesurfaceof the table wherethe saw is to be
mountedmusthavea holelargeenoughto facilitate
sawdustfall-throughandremoval.
3. Squarethesawon themountingsurfaceand mark
the!ocationofthefour3/8in. mounting holes (1).
4. Drill 3/8 in. hole into the mounting surface.
5. Mark an 11 in. square (2) centered between the four
mounting holes (1).
6. Cut out and remove the square.
7. This opening will allow sawdust to fal! through the
saw base.
8. Place the saw on the work surface, and align the
mounting holes of the saw with those drilled through
the surface.
9. Fasten the saw to the work surface.
WARNINGn
Do not operate this machine on the floor. This is very
dangerous and may cause serious injury.
Fig. B
IA wARNmNen
Failure to provide the sawdust fall-through hole for use
of the saw when mounted to a worksurface and not a
stand will cause sawdust to build up in the motor area,
which may result in fire or cause motor damage.
ASSEMBLE BLADE RAISING & TILTING WHEEL
(FIG. C}
1. Attach blade raising & tilting hand wheel (1) to the
height regulating bolt (2). Make sure the slot (3) in
the hand wheel hub is engaged with the roll pin (4) in
the height regulating bolt.
2. Fasten hand wheel to height regulating bolt with flat
washer (5) and dome nut (6).
Fig. C
6 5 2
4
3
1
RiP FENCE (FIG. D, E)
1. Thread the rip fence locking handle (2) into the
eccentric (3) of the fence and lock in place by
tightening the nut (1) against the fence head.
Fig. D
23__' I'"--'_ _____--1
KEEPING THE AREA CLEAN
1. Sawdust and wood chips that fai! from under the saw
will accumulate on the floor.
2. Make it a practice to pick up and discard this dust
when you have completed cutting.
10
Loading ...
Loading ...
Loading ...