Loading ...
Loading ...
Loading ...
14
INSTALL THE ICEMAKER
(continued)
Step 5
Remove the icemaker power
cord from the clip. Place the
icemaker on its side as shown.
Insert the icemaker power cord
plug (C) into the socket on the
side wall, making sure the prongs
and holes are matched. Press the
plug firmly into the socket.
C
Step 6
• Lift the icemaker so the fill tube
extension (10) fits the fill cup
opening (D). Hang the icemaker
on the 2 screws (B).
Make sure:
• The power cord is still firmly
in the socket.
• The fill tube extension (10) is
still in the fill cup opening.
(Check the rear of the refrigerator
to make sure the fill tube has
not been pushed out of the
back of the refrigerator.)
• The icemaker mounting screws
are located in the uppermost
position of the mounting slots.
THEN TIGHTEN THE
ICEMAKER MOUNTING
SCREWS SECURELY.
10
D
B
Step 7
The icemaker should feel secure
when you lift the icemaker
feeler arm (E) to the STOP (up)
position. Leave it there until the
refrigerator is connected to the
water supply to prevent
premature operation.
Step 8
Move the ice bucket (11) into
place under the icemaker.
NOTE: Check again to make
sure the icemaker power cord
plug is firmly inserted into its
socket with the prongs matched
to the corresponding holes.
Check again to make sure the
icemaker feeler arm (E) is in the
STOP (up) position.
Arm up–stops
operation
Up position
Arm down–icemaker
will operate
E
E
11
Step 10
The warranty for the icemaker
is printed in this guide. Keep
this guide with your
Refrigerator Use & Care Guide.
The icemaker installation inside
the freezer compartment is now
complete. Continue to the
Installing the Water Valve
Assembly section.
Step 9
A label (9) is provided in the kit
to record the date of installation
for warranty purposes. Apply it
to the back of the refrigerator.
G
Step 4
• Remove and discard the white
plug from the upper left corner
of the freezer wall.
• Cut the fill tube extension (10)
to the length (use the
template in this section) with a
sharp knife or single-edge
razor blade and slide it onto
the fill tube against the stop.
G
G
10
Remove
plug
Loading ...
Loading ...
Loading ...