Loading ...
Loading ...
Loading ...
Step 4
Remove the icemaker power
cord from the clip. Hold
the
icemaker
in the freezer
compartment as shown. Insert
the icemaker power cord plug
(B) into the socket on the rear
wall, making sure the prongs
and holes are matched. Press
the plug firmly into the socket.
Reinstall the electric plug
cover
If it matches Step 1, Figure 1:
• Remove the break-out tab on
the right side of the cover.
Hold the cover and twist off
the tab with pliers.
• Place the cover over the
electric plug with the power
cord running through the
opening.
• Insert the tabs in the top or
bottom and snap the other end
in place.
IMPORTANT: This cover will
help keep the electric plug from
coming out of the socket when
mounting the icemaker. Be sure
to reinstall it now.
B
Install the Icemaker
Step 5
• Lift the icemaker so the fill tube
extension (10) fits in the fill cup
opening (C). Hang the icemaker
on the two mounting screws (A).
Make sure:
• The power cord plug is still
firmly in the socket.
• The fill tube extension (10) is
still in the fill cup opening. (Check
the rear of the refrigerator to
make sure the fill tube has not
been pushed out of the back of
the refrigerator.)
• The icemaker mounting screws
are located in the uppermost
position of the mounting slots.
THEN TIGHTEN THE
ICEMAKER MOUNTING
SCREWS SECURELY.
C
A
10
Step 6
The icemaker should feel secure
when you lift the icemaker
feeler arm (D) to the STOP (up)
position. Leave it there until the
refrigerator is connected to the
water supply to prevent
premature operation.
Arm up–stops
operation
Arm down–icemaker
will operate
D
Step 7
Position the freezer shelf for
ice-making and move the ice
bucket (11) into place on the
shelf under the icemaker.
The straight 2-position shelf
should be in the lower position.
The step shelf’s lower step
should be under the icemaker.
The cantilever shelf’s top hooks
should be in the 6th slot up
from the bottom of the track.
NOTE: Check again to make
sure the icemaker power cord
plug is fully inserted into its
socket with the prongs matched
to the corresponding holes.
Check again to make sure the
icemaker feeler arm (D) is in
the STOP (up) position.
Step 9
The warranty for the icemaker
is printed in this guide. Keep
this guide with your
Refrigerator Use & Care Guide.
The icemaker installation inside
the freezer compartment is now
complete. Continue to the
Installing the Water Valve
Assembly section.
Step 8
A label (9) is provided in the kit
to record the date of installation
for warranty purposes. Apply it
to the back of the refrigerator.
D
11
11
Loading ...
Loading ...
Loading ...