Loading ...
Loading ...
Loading ...
13
Install the Icemaker
INSTALL THE ICEMAKER
Is this the right instruction for your model?
Follow Installation indicated by the label on the back
of the refrigerator—C, F, G or H.
Installation Instructions
CAUTION: Unplug the Refrigerator. To eliminate the danger
of electric shock during installation, you must unplug the
refrigerator from its electrical outlet.
Read each step thoroughly before proceeding.
Tools needed:
• Phillips-type screwdriver
• Blade-type screwdriver
• Sharp knife
• Pliers
Step 2
Remove the electric
plug cover from
the left side wall
on the inside of the
refrigerator and
discard it.
Pull the cover (A)
straight out while
pressing the sides
of the cover to
free its tabs from
the slots in the freezer wall.
Step 1
Insert the water tube inlet (15).
If the refrigerator already has a
water tube inlet on the back of
the refrigerator, got to Step 2.
Find the small label in the upper
right hand corner on the back of
the refrigerator. Peel off the
label.
On the tube side of the water
tube inlet (15) there is an
adhesive backing. Remove the
backing.
Slide the tube
into the hole
on the back
of the
refrigerator
as shown.
Firmly press
on the inlet to
secure it.
A
Step 3
Loosen the two mounting
screws (B) but do not screw
them all the way out. If your
model does not have the screws
already in the freezer wall, look
for two plug buttons. Remove
the plug buttons and insert the
two Phillips head screws (14).
The screws should extend
approximately 1/2″ (13 mm)
out from the freezer wall.
B
(continued next page)
Cut the fill tube extension to this length for .
G
G
Loading ...
Loading ...
Loading ...