Loading ...
Loading ...
Loading ...
9
Check that the voltage on the rating plate
corresponds to the voltage in the home.
Ensure that the appliance oven cavity is empty
before fitting.
Ensure that the appliance is not damaged. Check that
the microwave oven door closes firmly against the door
support and that the internal door seal is not damaged.
Empty the appliance oven and clean the interior with a
soft, damp cloth.
Do not operate this appliance if it has a damaged
mains cord, if it is not working properly, or if it has
been damaged or dropped. Do not immerse the
mains cord in water. Keep the cord away from hot
surfaces.
If the power cable is too short or damaged, it
must be replaced. The power cable must only be
replaced by a qualified technician in compliance
with the manufacturer's instructions and current
safety regulations. Contact an authorised After-
Sales Service.
For installation to comply with current safety
regulations, an omnipolar disconnect switch with
minimum contact gap of 3 mm must be used.
The appliance can be operated only if the
appliance oven door is firmly closed.
The earthing of this appliance is compulsory. The
manufacturer accepts no liability for injury to persons,
animals or damage to objects arising from the failure to
observe this requirement.
The manufacturers are not liable for any problems
caused by the user’s failure to observe these
instructions.
1. OPEN THE DOOR, remove the accessories and
ensure that the oven is empty. RINSE THE WATER
CONTAINER with tap water (no detergents) and
then fill it to the "MAX" mark.
SLIDE THE WATER CONTAINER into its socket until it
engages in the contact point and sits firmly in
place.
2. RUN THE CALIBRATION FUNCTION and follow on-
screen instructions.
NOTE
THE WATER PUMP responsible for filling and draining
the steam boiler is now activated. It will initially
sound louder while it is pumping air, and quieter
when water is filling the pump again.
THIS IS NORMAL, and no reason for alarm.
AFTER CALIBRATION, let the oven cool to room
temperature and then wipe dry any damp
areas if present.
EMPTY THE WATER CONTAINER and dry it off before
further use.
Follow the separate fitting instructions supplied
when installing the appliance.
Before first use
After connecting
Prior to connecting
Fitting the appliance
Loading ...
Loading ...
Loading ...