Loading ...
Loading ...
Loading ...
I AudioDubbing
The audio track can be customized only when
recorded in the 12-BIT and SP modes.
( "pg. 32)
• Use the provided remote control.
Stereo Microphone
1 Play back the tape to locate the point where
editing will start, then press PAUSE (11).
2 While holding A. DUB ( # ) on the remote
control, press PAUSE (11).The "11_" indicator
appears.
3 Press PLAY (1_), then begin "narrating".
Speak into the microphone.
• To pause dubbing, press PAUSE (11).
4 To end Audio Dubbing, press PAUSE (11),
then STOP (ll).
To hear the dubbed sound during playback
Set "NARRATION" to "ON" or "MIX".
("pg.31,35)
NOTES:
• Sound is not heard from the speaker during Audio
Dubbing.
• When editing onto a tape that was recorded at
12-BIT, the old and new soundtracks are recorded
separately.
• If you dub onto a blank space on the tape, the
sound may be disrupted. Make sure you only edit
recorded areas.
• If feedback or howling occurs during TV playback,
move the camcorder's microphone away from the
TV, or turn down the TV's volume.
• If you change from 12-BIT to 16-BIT in mid-
recording and then use the tape for Audio
Dubbing, it is not effective from the point where
16-BIT recording began.
• During Audio Dubbing, when the tape moves to
scenes recorded in the LP mode. scenes
recorded in 16-BIT audio or a blank portion, Audio
Dubbing stops.
EDITINGEN45
I InsertEditing
You can record a new scene into a previously
recorded tape, replacing a section of the original
recording with minimal picture distortion at the in
and out points.The original audio remains
unchanged.
• Use the provided remote control.
NOTES:
• Before performing the following steps, make sure
that 'TIME CODE" for DISPLAY in both Recording
and Playback Menus is set to ON".
( pg.31, 34, 35)
• Insert Editing is not possible on a tape recorded in
the LP mode or on a blank portion of a tape.
1 Play back the tape, locate the Edit-Out point
and press PAUSE (11). Confirm the time code at
this point.(pg.20)
2 Press REW (-,441)until the Edit-In point is
located, then press PAUSE (11).
3 Press and hold INSERT (o) on the remote
control, then press PAUSE (11).The "110 "
indicator and the Time Code (min.:sec.) appear
and the camcorder enters Insert-Pause mode.
4 Press START/STOP to begin editing.
• Confirm the insert at the time code you checked in
step |.
oTo pause editing, press START/STOP. Press it
again to resume editing.
5 To end Insert Editing, press START/STOP,
then STOP (11) on the remote control.
NOTES:
• Program AE, Effects and Shutter Effects
( pg. 41) can be used to spice up the scenes
being edited during Insert Editing.
• During Insert Editing, the date and time
information changes.
• If you perform Insert Editing onto a blank space
on the tape, the audio and video may be
disrupted. Make sure you only edit recorded
areas.
• During Insert Editing, when the tape moves to
scenes recorded in the LP mode or a blank
portion, Insert Editing stops. ( "pg. 49)
Loading ...
Loading ...
Loading ...