Loading ...
Loading ...
Loading ...
137
Installation
www.bora.com
EN
[1] Activated charcoal filter
[2] Grip strap
X Remove the packaging from the activated charcoal
filter [1].
X Position the activated charcoal filter correctly
with the help of the printed symbols (arrow left,
grip strap [2] right).
X Hold the activated charcoal filter at both ends.
X Bend the activated charcoal filter into a cylindrical
shape so that both ends of the filter are opposite
each other.
Fig. 10.33 Inserting the activated charcoal lter
through the vent opening
X Tilt the activated charcoal filter towards you
slightly and insert it through the inlet opening.
X Guide the left end of the filter into the opening in
the filter housing.
Fig. 10.34 Placing the activated charcoal lter in the
end position
X Push the activated charcoal filter into the filter
housing until it will go no further (to do this,
you can place one finger between the slats and
gradually push the filter into the housing).
O
The end position of the activated charcoal filter
is reached when the filter has been fully pushed
inside the filter housing.
X Push the telescopic pull-out [1] until it is tight up
against the back panel of the unit [3].
O
With the telescopic pull-out the distance to the
back panel of the unit can be flexibly bridged.
X Check that the telescopic pull-out [1] fits
accurately, is flush with the cut-out on the back
panel of the unit [3] and closes it off.
X Secure the telescopic pull-out [1] to the back
panel of the unit [3] using the adhesive tape [2]
10.7.10 Inserting the activated
charcoal filter
i
Removing the filter – see
„8.6 Replacing the activated charcoal filter“
2
1
Fig. 10.31 Remove the lter replacement cover
[1] Filter replacement cover
[2] Inlet opening
X Inside the inlet opening [2] pull the filter
replacement cover [1] out through the opening in
the filter housing.
OBEN / TOP
2
1
Fig. 10.32 Activated charcoal lter
Loading ...
Loading ...
Loading ...