Loading ...
Loading ...
Loading ...
131
Installation
www.bora.com
EN
10.6.5 Connecting the appliance to
the duct system
i
The duct system must be fitted to the
appliance free of load and with the power
supply switched off.
i
For correct installation, the drawers of the floor
unit must be shortened depending on the
installation situation.
i
When attaching the seals, ensure that an
airtight seal is created with the connecting
duct piece when the seals are compressed.
X Use only BORA Ecotube duct parts.
X Do not use flexible or fabric hoses.
1
3
2
Fig. 10.16 Connecting the duct system
[1] Seal
[2] Duct part
[3] Exhaust opening
X Pull the seal [1] onto the exhaust opening [3] on
the appliance. To do this, the seal [1] will need to
be stretched slightly.
X Push the duct part to be connected [2] with the
coupling onto the exhaust opening [3] with the
seal [1].
X Ensure that the seal [1] is not displaced.
[1] Cooktop
[2] Holding clamp
[3] Worktop
X When aligning the cooktop, ensure that the
holding clamps hold the cooktop in the worktop.
Information regarding surface mounting:
X make sure that the cooktop sealing tape is flat
against the worktop.
Information regarding flush installation:
X make sure that the cooktop sealing tape is well
sealed all the way round.
Height adjustment plates for flush installation
(optional)
1
2
Fig. 10.14 Inserting height adjustment plates
[1] Cooktop
[2] Height adjustment plate
1 2
Fig. 10.15 Height adjustment plates
[1] Sealing tape
[2] Optional height adjustment plates
O
The height adjustment plates are self-adhesive to
prevent slipping during installation.
X If applicable, insert the height adjustment plates
[2].
X Place the height adjustment plates next to the
sealing tape [2].
Loading ...
Loading ...
Loading ...