Loading ...
Loading ...
Loading ...
PropercareandcleaningareimportantsoyourrangewilI
giveyouefficientandsatisfactoryservice°Followthese
directionscarefullyincaringforittohelpassuresafeand
propermaintenance.
BE SURE ELECTRICAL POWER IS DISCONNECTED
BEFORE CLEANING ANY PART OF YOUR RANGE.
Sealed Burner Assemblies
(on some models)
CAUTION: Do NOT OPERATE THE
BURNER WITHOUT ALL BURNER PARTS AND DRIP
PANS (IF SO EQUIPPED) IN PLACE°
Grate
_t/_ _\ , Burner cap
..... . Drippan (on somemodels)
(_ Burner head
S_/ _ \._ Electrode
Turn all controls off before removing burner parts
and drip pans (if so equipped).
The burner grates, caps, heads and drip pans (if so
equipped) can be lifted off, making them easy to clean
For proper ignition,
make sure the small
hole in the section that
fits over the electrode
is kept open.. A sewing
needle or wire twist tie
works welt to uncfog it..
The slits in the burner
heads of your range must be kept clean at all times for
an even, unhampered frame,
You should clean the surface burners routinely, especially
after bad spillovers, which could clog these openings.
To remove burned-on food, soak the burner heads
in a solution of mild liquid detergent and hot water
for 20-30 minutes For more stubborn stains, use
a toothbrush_
Before putting the burner head back, shake out excess
water and then dry it thoroughly by setting it in a warm
oven for 30 minutes..
Replace the burner
heads and caps. Make
sure that the heads and
caps are replaced on
the correct size burner.
There is one small,
2 medium and one
After cleaning,
large cap. make sure the slot
NOTE; On some in the burner head
is positioned over
models the heads and the electrode
caps are all the same
size and can be used in any of the 4 needed locations.
The electrode of the
spark igniter is exposed
when the burner head
fs removed. When one
burner is turned to LITE, all the burners spark..
Do not attempt to disassemble or clean around
any burner while another burner is on..An electric
shock may result, which could cause you to knock
over hot cookware.
Burner Heads
(on sealed burners only)
NOTE: Before removing the burner heads and caps,
remember their size and location.. Replace them in the
same location after cleaning.
Burner Caps
(on sealed burners only)
Lift off when cool, Wash burner caps in hot, soapy water
and rinse with clean water. You may scour with a plastic
scouring pad to remove burned-on food particles_
Dry them in a warm oven or with a cloth--don't
reassemble them weL Replace the burner caps..
Make sure that caps are replaced on the correct size
burner. There is one small, 2 medium and one large cap.
Left Drip Pan Right Drip Pan
Medium __ Mediu Smali
Large-- Medium[_ _ Large
Front of range
NOTE: On some models the caps are all the same size
and can be used in any of the 4 needed locations.
29
(continued next page)
Loading ...
Loading ...
Loading ...