Loading ...
Loading ...
Loading ...
38
W415-0748 / 12.12.08
8.0 OPERATION
8.1 GENERAL TRANSMITTER LAYOUT
THERMOSTAT
OFF/ON/SMART
ROOM
TEMPERATURE
LOW BATTERY
ALARM
CHILD SAFETY
LOCK OUT
TRANSMISSION
AUX. OUTPUT
FANFLAME
TEMPERATURE SET POINT/ LEVEL/ STATUS
6
35.1
8.2 FIREPLACE OPERATION
● Install 4 AA batteries into the receiver battery bay as indicated on the battery cover (+/-). (Only required
as back up to household electricity). Refer to “CONTROL ACCESS” section to locate the receiver
battery bay which requires a qualified technician.
● Place the 3 position slider switch in the “Remote” position.
● Using the end of a paper clip, or other similar object, insert the end of the paper clip into the hole
marked “PRG” on the receiver front cover. The receiver will “beep” three (3) times to indicate that it is
ready to synchronize with the transmitter.
● Install the 3 AAA batteries in the transmitter battery bay, located on the base of the transmitter. With the
batteries already installed in the transmitter, push the “ON” button. The receiver will “beep” four times to
indicate the transmitter’s command is accepted and set to the particular code of that transmitter. The
system is now initialized.
35.2
8.3 HAND HELD REMOTE OPERATIONS
● Press the ON/OFF key on the transmitter. The transmitter display
will show all active icons on the screen. A single “beep” from the
receiver will confirm reception of the command.
BLUE LCD DISPLA
Y
ON/OFF KEY
THERMOSTAT KEY
UP/DOWN
ARROW KEY
MODE KEY
35.4
FIGURE 8.1
FIGURE 8.3
If you do not follow these instructions exactly, a fire or explosion may result causing property damage, personal
injury or loss of life.
Always light the pilot whether for the first time or if the gas supply has ran out with the glass door opened or removed.
!
WARNING
8.2.1
8.2.2
8.2.3
8.2.4
8.3.1
Loading ...
Loading ...
Loading ...