Loading ...
Loading ...
Loading ...
37
W415-0748 / 12.12.08
Your comes equipped with our “Night Light™”.
The light has been pre-wired and is controlled from the remote
control.
If in the event the lamp or lens needs to be replaced, follow the
instructions below.
Unplug the wire harness / transformer from the FCM (Fan Control
Module) inside the fi replace.
Remove the four screws that secure the lens frame.
This frame retains the glass lens. The lamp can now be accessed.
NOTE: Do not handle the lamp (bulb) with bare fi ngers, protect with a clean
dry cloth.
The lamp will pull straight out of the socket. Replace with Wolf Steel parts only, as
lamp and lens are special “high temperature” products. When re-installing, ensure
integrity of gasket seal.
THE FIREBOX MUST BE SEALED.
Over tightening the screws could break the lens.
“Light Leakage” from the upper area may be observed. The holes in the lamp housing are necessary
for ventilation and must not be covered.
SCREWS
LENSE
FRAME
FIREBOX TOP
FIGURE 7.4b
GASKET
LENSE
FRAME
COLOURED SIDE UP
FIGURE 7.4a
7.3.1 Remove optional front, see “AFK / WI FACE KIT
INSTALLATION” section.
7.3.2 Tilt the control panel forward and remove allowing
access to the electrode box which is screwed to
the base of the fi rebox.
7.3.3 Pull back on the battery compartment door latch
and remove.
7.3.4 Replace battery.
7.3.5 Reinstall battery compartment and control doors.
FIGURE 7.3
7.3 SPARK MODULE BATTERY REPLACEMENT
7.4 NIGHT LIGHT™ REPLACEMENT
Loading ...
Loading ...
Loading ...