Loading ...
Loading ...
Loading ...
REMOVING AND INSTALLING SAWBLADE
WARNING: FOR YOUR OWN SAFETY, TURN SWITCH
"OFF" AND REMOVE PLUG FROM POWER SOURCE
OUTLET BEFORE REMOVING OR INSTALLING
SAWBLADE.
1. Remove insert.
2. Place OPEN END wrench on flat surfaces of saw
ARBOR ... BOX wrench on nut ... position
wrenches as shown ... hold your hands well above
blade.
3. With OPEN END wrench against table, PULL BOX
wrench FOREWARD to LOOSEN nut.
4. To TIGHTEN nut ... HOLD open end wrench against
rear of table ... PUSH box wrench toward rear.
PULL TO LOOSEN
OPEN END
WRENCH
FLAT SURFACES COLLAR
When installing the blade ... make sure the teeth are
pointing toward the front of the saw ... and that the
blade and collars are clean, and free from any burrs.
The HOLLOW side of the collars must be against the
blade.
Always tighten the arbor nut securely.
ON-OFF SWITCH
TEETH POINTIN(
FRONT OF SAW
HEX NUT
l
CAUTION: Before turning switch on, make sure the blade
guard iscorrectly installed and operating properly.
The On-Off Switch has a locking feature. THIS SHOULD
PREVENT UNAUTHORIZED AND POSSIBLY
HAZARDOUS USE BY CHILDREN AND OTHERS.
1. Insert key into switch.
2. TO turn saw ON ... stand to either side of the blade
never in line with it ... insert finger under switch lever
and pull END of switch out.
After turning switch ON, always allow the blade to
come up to full speed before cutting.
Do not cycle the motor switch on and off rapidly, as
this may cause the sawblade to loosen. In the event this
should ever occur, allow the sawblade to come to a
complete stop and retighten the arbor nut normally,
not excessively. Never leave the saw while the power is
"ON".
3. TO turn saw OFF ... PUSH lever in. Never leave the
saw until the cutting tool has come to a complete stop.
TO lock switch in OFF position ... hold switch IN
with one hand ... REMOVE key with other hand.
WARNING: FOR YOUR OWN SAFETY, LOWER
BLADE OR OTHER CUTTING TOOL BELOW TABLE
SURFACE, AND ALWAYS LOCK THE SWITCH
"OFF". WHEN SAW IS NOT IN USE ... REMOVE
KEY AND KEEP IT IN A SAFE PLACE ... ALSO
... IN THE EVENT OF A POWER FAILURE (ALL
OF YOUR LIGHTS GO OUT) TURN SWITCH OFF
• .. LOCK IT AND REMOVE THE KEY. THIS WILL
PREVENT THE SAW FROM STARTING UP AGAIN
WHEN THE POWER COMES BACK ON.
KEY
_ON-OFF SWITCH
©
KEY
(YELLOW PLAS_IC)
Loading ...
Loading ...
Loading ...