Loading ...
Loading ...
Loading ...
assembly
WiNG SCREW
CARRIAGE BOLT
INSTALLING BLADE GUARD
Find the parts shown among the loose parts ... attach
to spreader support rod at the back of the saw ...
screw in wing screws ... screw on nuts but DO NOT
TIGHTEN THEM.
CLAMP BLOCK
2. Turn ELEVATION crank counterclockwise until blade
is up as high as it will go.
IMPORTANT: BLADE must be SQUARE 90 ° to
TABLE, in order to INSTALL Blade Guard Correctly.
Check for Blade SQUARENESS, according to "BLADE
TILT" adjustments. See ADJUSTMENTS section
further on in this manual.
Place RIP FENCE on table ... CAREFULLY move it
against blade so that it is parallel to the blade, and just
TOUCHES tips of saw teeth ... tighten RIP FENCE
LOCK KNOB.
6
Loading ...
Loading ...
Loading ...