Loading ...
Loading ...
Loading ...
Note: A protective plastic cap may have been inserted in the fuel
fill opening during manufacturing. Remove and dispose.
1. Clean around fuel filler neck before removing the fuel cap.
(see Fig. 5)
2. A fuel level indicator small basket is located inthe fuel tank.
Fill the tank until the fuel reaches the fuel level indictor. Be
careful not to overfill.
Controls and
H
Features
E
D C B
A
F
Fuel Cap
Figure 5
K
Adding Oil
z_ CAUTION
The engine is shipped without oil in the engine.
You must fill the engine with oil before operation.
Running the engine with insufficient oil can
cause serious engine damage and void the
engine warranty.
1. Remove the oil filler cap and dipstick. Wipe the dipstick
clean (see Fig. 6).
2. Slowly add oil until the oil level registers between high hole and
low hole. Refer to the Engine Maintenance section for the
correct oil viscosity and engine oil capacity.
Note: Use a 4 cycle, SAE 5W-30, or Equivalent Oil.
Cap
\_ Dipstick
Fill between the high and low marks
Figure 6
Figure 7
Parts List for Snow Thrower
A. Auger Control
B. Shift Lever
C. Chute Direction Control
D. Chute Tilt Control
E. Drive Control
F. Headlight
G. Chute directional support
H. Discharge chute
I. Clean-out tool
J. Main auger housing
K. Auger
L. Wheel
M. Skid shoe
Auger Control: Used to engage and disengage the
drive to the auger.
Important! Refer to Auger Control Test prior to
operating your snow thrower. Read and follow all
instructions carefully and perform all adjustments to
verify your snow thrower is operating safely and
properly.
Loading ...
Loading ...
Loading ...