Loading ...
Loading ...
Loading ...
POCKET CUTTING (Fig, 13)
z_ WARNING; Always adjust
the bevel setting to 0 ° before
making a pocket cut. Attempt-
ing a pocket cut at any other
setting can result in loss of
control of the saw, possibly
causing serious injury°
1, Disconnect the saw from
the power source.
2, Adjust the bevel setting to
zero°
Fig° t 3 Lower blade
guard lever
3_ Set the blade to the cor-
rect depth of cut,,
/
4. Plug the saw into a power source.
5. Swing the lower blade guard up using the lower blade guard lever°
6. Hold the lower blade guard by the lever°
7. Rest the front of the base flat against the workpiece with the rear of the
handle raised, so that the blade does not touch the workpiece.
8. Start the saw and allow the blade to reach full speed°
9. Guide the saw into the workpiece, and make the cut.
,_ WARNING: Always cut in a forward direction when making a pocket cut. Cut-
ting in the reverse direction could cause the saw to climb up on the workpiece and
back toward you, possibly causing serious injury.
t 0o Release the trigger switch and allow the blade to come to a complete stop,
11. Lift the saw from the workpiece.
!2. Clear corners out with a hand saw or sabre saw.
WARNING; Never tie the lower blade guard in a raised position. Leaving the
blade exposed could lead to serious injury.
28191 ManuaLRevised 07-O202 Page 23
Loading ...
Loading ...
Loading ...