Loading ...
Loading ...
Loading ...
3_
After completing the cut, release the trigger switch and allow the blade to come
to a complete stop. After the blade has stopped, remove the saw from the work-
piece,,
For making 45 ° bevel cuts,
there is a notch in the saw
base to help you line up the
blade with the cutting line.
Align your cutting line with the
notch marked 45 °. (Fig° 11 a)
,_ WARNING; Attempting
bevel cut without the beveL-
adjustment knob securely
tightened can result in serious
injury.
O°Bevei stop
Fig. 1la
Une of cut
t_j. - 45° indicator
The saw has a 0°bevel stop that has been factory adjusted to assure a 0°angle of
the saw blade when making 90°cuts.
To check 0 ° bevel stop (Fig. 12)
_k WARNING; Always disconnect the saw from the power source when assem-
bling parts, changing the blade and making adjustments° Failure to obey this warn-
ing could cause serious personal injury.
I. Disconnect the saw from the power source.
2o Place the saw in an upside-down position on a workbench.
3. Using a carpenter's square, check that the saw blade is square to the base of
the saw,
To adjust 0 ° bevel stop (Fig, 12)
1. Disconnect the saw from
the power source.
2. Loosen the bevel-adjust-
ment knob.
3. Place the saw in an up-
side-down position on a
workbench.
4_
Using a hex key, turn the
0°bevel-stop adjusting
screw until it is square with
the saw blade.
Fig. t2
"_ 0° bevel_stop
adjustment screw
Bevel adjustment
knob
28191 ManuaLRevised 07-0202 Page 22
Loading ...
Loading ...
Loading ...