Loading ...
Loading ...
Loading ...
STARTING/STOPPIING THE
SAW (Fig. 4)
To start the saw: Depress the
trigger switch. Always allow
the blade to reach full speed,
then guide the saw into the
workpiece.
To stop the saw: Release
the trigger switch. After you
release the trigger switch,
allow the blade to come to
a complete stop_ Do not
remove the saw from the
workpiece while the blade is
moving,
Fig° 4
Trigger Switch
DEPTH-OF-CUT ADJUST-
NIENT (Fig. 5)
Always keep the correct depth-
of-cut setting. The correct
depth-of-cut setting should
not exceed 1/4 inch below the
material to be cut. Only one
saw-blade tooth should show
beneath the material. If more
than one blade tooth shows,
then the depth of cut is too
deep. Excessive depth of cut
will increase the chance of
kickback and cause the cut to
be rough.
Fig. 5
Depth Scale
Depth Indicator
Depth-of_Cut
Adjustment
Lever
TO ADJUST DEPTH OF CUT
o Disconnect the saw from the power source.
,, Loosen the depth-of-cut adjustment lever°
o Place the base flat on the workpiece, and raise or lower the saw until the depth-
of-cut indicator aligns with the desired depth on the scale.
o Securely tighten the depth-of-cut adjustment lever_
NOTE: Make a trial cut on a piece of scrap material to ensure that the laser is
aligned properly.
28191 Manual Revised_07-0202 Page 17
Loading ...
Loading ...
Loading ...