Loading ...
Loading ...
Loading ...
7_
.
g_
When restarting a saw in the workpiece, center the saw blade in the kerf and
check that saw teeth are not engaged into the material,. If saw is binding, it may
walk up or kickback from the workpiece as the saw is restarted.
Support large panels to
minimize the risk of blade
pinching and kickback,
Large panels tend to sag
under their own weight.
Supports must be placed
under the panel on both
sides, near the line of cut
and near the edge of the
panel.
Do not use dull or dam-
aged blades. Unsharpened
or improperly set blades
produce narrow kerf caus-
ing excessive friction, blade
binding and kickback.
Fig. 2
Correct Sup'port ..... _j I
support is close enough to cut line
10. Blade depth and bevel adjusting locking levers must be tight and secure before
making cut. if blade adjustment shifts while cutting, it may cause binding and
kickback.
11. Use extra caution when making a "pocket cut" into existing walls or other blind
areas° The protruding blade may cut objects that can cause kickback.
28191 Mammal Revised_07-0202 Page 12
Loading ...
Loading ...
Loading ...