Loading ...
Loading ...
Loading ...
,_ WARNING: ALWAYS securely clamp and support the workpiece. ALWAYS
maintain proper control of the saw. Failure to clamp and support the workpiece
and loss of control of saw could result in serious injury°
MAKING CROSS CUTS AND
RIP CUTS (Fig. 9)
When making a cross cut or
rip cut, align your cut line with
the notch marked 0° on the
saw base° Since blade thick-
nesses va_, always make
a trial cut in scrap material
along a guideline to determine
how much, if any, the guide-
line must be offset to produce
an accurate cuL
Fig. 9
Crosscut ruler
A ruler for measuring cross
cuts is marked along the front of the saw base.
MAKllNG RiP CUTS
Always use a guide when making long or wide rip cuts with your saw, You can
use either a straight edge or use the edge guide that was included with the saw,
1. Securethe workpiece.
2. Clamp a straight edge to the workpiece using C-clamps.
3. Carefully guide the saw along the straight edge to achieve a straight rip cut,
EDGE GUIDE
The saw comes with an edge
guide. It allows you to make ac-
curate parallel cuts when trim-
ming a workpiece. The edge
guide attaches to the saw
base and is secured in place
with a turn screw. The arm of
the edge guide is stamped
with a scale from 0 to 9 inches
in 1/8-inch increments for eas-
ily adjusting your cut.
Fig_ 10
Using the edge guide (Fig. 10)
Always use a guide when
making long or wide rip cuts with your saw. You can use either a straight edge or
use the edge guide that was included with the saw.
28191 Manuat Revised_07-0202 Page 20
Loading ...
Loading ...
Loading ...