Loading ...
Loading ...
Loading ...
3. TV Connections 25
A/V Reoeiver
Most setups require either a digital audio cable or
analog stereo audio cables.
The TV makes all audio available in digital and analog
formats:
[] Analog audio coming into the TV is available as
output in digital stereo format on the DIGITAL
AUDIO OUTPUT jack (TV back panel #2).
[] Digital incoming audio is available as analog
output on the AVR AUDIO OUTPUT, L and R
jacks (TV back panel #1).
Usually, only one of the following connections is
required:
• To connect an analog A/V receiver
Connect left (white) and right (red) audio cables
from AVR AUDIO OUTPUT, L and R on the TV back
panel #1 to the TV AUDIO INPUT on the A/V receiver.
• To connect a digital A/V receiver with Dolby
Digital surround sound and PCM audio support:
Connect one end of the dic ital audio cable to
DIGITALAUDIO OUTPUT on the back of the TV
(back panel #2). Connect the other end to the
COAXIAL DIGITAL INPUT on the back of the A/V
receiver.
NV Receiver Panel
Note:
[] On rare occasions, an HDMI signal may be
copy-restricted and cannot be output from
the TV as a digital signal. To hear these copy-
protected signals through the A/V receiver, use
connections for analog A/V receivers.
Check the A/V receiver's Owner's Guide for
information concerning use of the digital input
and switching between digital sound and
analog stereo sound from the TV.
Required: 3 coaxial cables, one two-way RF splitter.
These are not included with the TV.
Note: This connection is not recommended. The
other connections described in this chapter
provide better quality audio and video to the TV
and allow NetCommand to work with cable box.
1. Connect the incoming cable to IN on cable box.
2. Connect one coaxial cable from OUT on the cable
box to ANT l/MAIN on the TV back panel #2.
I
TV Back Panel #2 1
Figure 11. Connecting the TV to an A/V receiver
BACKINPUT PANEL#2
belOW label wl(nln re(essee area - a( t(
TV Back Panel #2
@
To ANT t/MNN
:::: _ }{;J _iiiiii;i ;;;i;
1.
i!7:7!; i!i!i!i!i!i!i!7,!7 iTii'i¸
Incoming
Cable
Figure 12. Connecting an older cable box
Loading ...
Loading ...
Loading ...