Loading ...
Loading ...
Loading ...
4-2
Wa
rning:
If the calibration process failed, the Red L
ED will be flashing and [E06] will be displayed
on the screen. Power off the scanner and then repeat the calibration step again.
Wa
rning:
Do not interrupt the calibration sequence or try to shut off the device while it is
calibrating. If you stop the calibration before it has completed, a calibration error may
occur. As a result, you will have to power off the unit and repeat the instructions in
this section.
Calibrate the scanner only when color of the scanned image looks abnormal.
Keep the calibration sheet from dust and debris. Any dirt may make the calibration
chart invalid or impact the calibration result.
Use only the included calibration sheet to calibrate the scanner.
4.2 Clean the Rollers and Glass
It is recommended to clean the scanner approximately every 200 scans or if vertical lines
or stripes appear on the scanned image.
To clean the rollers and glass:
1. Turn the scanner over to reveal the rollers and glass.
2. Wipe the rollers and the glass with the included cleaning cloth as illustrated.
3. Wipe the scanner with a dry and clean lint-free cloth.
Rollers
Glass
Note:
Adding some isopropyl alcohol (95%) on the cleaning cloth is more efficient when
cleaning the rollers.
Do not use any solvents or corrosive liquid (i.e., alcohol, kerosene, etc.) to clean any
part of the scanner, otherwise the plastic material will be permanently damaged.
Make sure the surface of the document or photo doesn’t have any paper clips, etc. or
this could damage the scanner glass lens.
Loading ...
Loading ...
Loading ...