Loading ...
Loading ...
Loading ...
ASSEMBLY INSTRUCTIONS
ASSEMBLY OF SNOW BLADE TO *
MODEL NO. 502 TRACTORS
Use all parts packed loose in Carton, and all
parts in Bag (A), Bag (C), Bag (D) and Bag (E).
Discard Carton(B)
Not all parts in Hardware Package will be
used
Attach frame brackets (R.H, and L.H.) to the inside of
tractor frame using the front hole inthe brackets and the
hole ineach side oftractor frame that is atthe front ofthe
foot rest and the back edge of the engine. See figure 9.
Fasten each bracket with one 3/8" x 1" hex bolt, lock
washer and lock nut: (Note that brackets are positioned
with the bends pointingin, the notched side to the front
and the four holes at the bottom,) 00 not tighten. See
figure 9.
e
O
Remove the four bolts which fasten the cross brace to
the frame assembly and repos.ition and fasten the brace
using the back set of holes in the frame assembly.
Tighten. See figure 7,
Assemble axle pivot bracket to the inside of the front
plate on frame assembly using two 3/8" x l" hex bolts,
3/8'! lock washers and 3/8" lock nuts. Tighten. See
figure 7.
AXLE PIVOT
3/8" x 1" HEX BOLTS
3/8" x 3/4" HEX BOLTS
3/8" LOCK CROSS !
WASHER BRACE
3/8" LOCK
FRAM E ASSEMBLY
LOCK
WASHER
3/8" LOCK
NUT
FIGURE 7
o
Using the top and bottom holes on both sides ofthe pivot
support bracket, attach itto the outside of the front plate
oftheframe assembly using four 3/8" x 1" hex bolts, lock
washers and lock nuts. Tighten. See figure 8.
3/8" LOCK NUT
3/8" LOCK
WASHER
._ 3/8" x 1"
. .._ HEX BOLT
PIVOT SUPPORT BRACKET
FRAME
ASSEMBLY
FIGURE 8
THIS HOLE
FIGURE 9 (Right Hand Side View)
• Attach blade frame assembly to the tractor frame by
inserting the axle pivot bracket into thehole inthe center
of the axle. See figure 10.
O
Attach the blade frame assembly to frame brackets
(R.H. and L.H.) using the bottom front hole on each
bracket and the bottom rear holes on both sides of the
frame assembly. Use two 3/8" x 1"bolts, 3/8" locl_washers
and 3/8" lock nuts. DO not tighten. See figure 10.
AXLE PIVOT BRACKET AXLE HOLE
FRAME
BRACKET (LH.)
3/8" HEX NUT
3/8" LOCK
WASHER
FIGURE 10
HEX BOLT
(Right Hand Side View)
Loading ...
Loading ...
Loading ...