Loading ...
Loading ...
Loading ...
ASSEMBLY INSTRUCTIONS ....
o
e
Lower the mower lift assembly.
Starting at the rear of the foot rest, remove and discard,
if present, the two bolts in the bottom set of holes as
illustrated in figure 4. Repeat on opposite side foot rest,
• Place a 3/8" x 3/4" hex bolt in ear of both brace mount
brackets as shown in figure 4. Now, using the two small
bottom slots in the brace mount brackets, attach both
brackets (R,H and L.H,) underneath both sides of the
tractorframe using four 3/8"x 1"hex bolts, lock washers
and look nuts, (Brackets should be positioned on the
inside of the frame with ears to the rear end pointing
outward,) Do not tighten. See figure 4,
REAR FENDER 3/8" x 1" HEX BOLT
BOLTS REMOVED FROM
THESE TWO HOLES
FOOT REST
BRACE
MOUNT
BRACKET
!
3_"LOCK
" WASHER
3_"HEXLOCKNUT
3/8" X 3/4" HEX BOLT FRONT-----_
FIGURE 4 (Right hand side view
• Raise the mower lift assembly,
• 811debladeframeassemblyundertractor,withthebrace
tubesat the rear.
Attach brace tube to brace mount bracket using the
3/8" x 3/4" hex bolt already assembled tn previous step.
Secure with a 3/8" lock washer and 3/8" lock nut. Repeat
this step on opposite side, Do not tighten at this time.
See figure 5,
3/8" LOCK
WASHER _ T _'_
[ BRACE TUBE (R.H.)
3/8" LOCKNUT
FRONT
FIGURE 5
(Right hand aide view)
6
Attach blade frame assembly to inside of tractor frame
by aligning holes in pivot plate bracket with holes in front
end of tractor ,frame and holes in frame reinforcement
brackets, Secure using two 3/8" x 1-1/4" hex bolts, 3/8"
flat washers, 3/8" lock washers and 3/8" lock nuts.
Tighten, See figure 6.
FRAME
REINFORCEMENT
BRACKETS
TRACTOR
3/8 FLAT
WASHER
J 3/8" x %1/4"
HEX BOLT
I
3/8" PIVOT
LOCK PLATE
WASHER BRACKET
FIGURE 6
0
Atthis time tighten ail ofthe following bolts previously left
untightened.
Tighten the 4 bolts fastening the frame reinforcement
bracket to the tractor frame.
Tighten the 4 bolts fastening the tube braces to the
frame assembly.
Tighten the 2 bolts fastening the tube braces to the
brace mount brackets.
Tighten the 4 bolts fastening the brace mount brackets
to the tractor frame.
See FINAL ASSEMBLY on page 11 to complete your
hook up,
Loading ...
Loading ...
Loading ...