Loading ...
Loading ...
Loading ...
For your convenience, First Time Set up menu will
be displayed on screen when the set is turned on
for the first time, If needed, follow the menus and
procedures displayed on-screen for setting up the
features.
The language 0f ihe onzscreen display is set to English
as the factory setting.
Press to select "ANT In".
Press to select "Cable" or
"Antenna".
Press to select "English,"
"Espa5or' or "Frangais".
i RETURN
@
i Language
Press to go to previous
screen. Or, select icon,
then press OK for same
results.
you can scan A!l(Analog and Digital) channels. If
needed, follow the menus and procedures displayed
on-screen for setting up the features. You can also make
the settings in Setup menu.
Press to select "Auto
program".
Press to display Auto program
screen.
Auto program
Press to select Mode.
Press to select "All" or
"Analog".
Press to select "Start scan".
Press to start.
Channels available for
reception will be set
automatically.
After Auto program is complete, the unit will return
to Manual program mode. To place the channels
that were located by auto scan in memory, move the
cursor to "Apply" and press OK. (p. 30-31)
If OK is not pressed after selecting APPLY, the
channels wil! not be memorized.
Notes:
• After "Auto program" is completed the unit tunes to the first
channel found during "Auto program".
• If setup is incomplete, check connection of Antenna/Cable to
the RF IN Terminal. then try "Auto program" again. (p. 29)
• "Auto program" must be done when you select the input
signal for the first time or whenever you change the antenna
configuration.
• Depending on conditions. "Auto program" may take a while.
25
Loading ...
Loading ...
Loading ...