Loading ...
Loading ...
Loading ...
The Power Indicator
LED ACTION
Off Power - OFF
Red (blinking) Power - OFF (Now cooling)
Green Power - ON
Green (blinking) Power- ON (Preparing to light tamp)
• If the POWER button is accidentally turned off during use,
after power is turned back on, it may take a short period
before the lamp automatically comes on.
• After the unit is turned on, maximum picture brightness wilt be
achieved in 5-10 minutes. This is normal.
• This unit consumes approx. 0.4 w in OFF condition when
plugged into an AC outlet.
Press POWER on Projection Display or Remote Control
to turn power on.
The Power Indicator blinks Green for about 20 seconds
and then turns solid Green.
A!waYs be sure to fo!10w the procedure given below to
turn th e projecti0n D!sPlay power ON and OFF.
•The !amp cooling fan will continue to operate for
approximately ! minute after the power is turned off. During
this time_the POWERindicator wilt blink Red.
Do not disconnect the power cord from the outlet
and donot open the circuit breaker (unless
necessary) while the COOling fan is still operating. Do
not disconnect the power cord from the power outlet
while the power indicator blinks Red.
POWER button/
POWER indicator
Press POWER on Projection Display or Remote Control
to turn power off.
Power shuts off after a Black Screen is displayed for a
few seconds.
Note:
• If the POWER button is pressed during the Black Screen
display, Power is turned back on.
The Power Indicator blinks Red for about 1 minute and
then LED turns off.
Note:
• When the power cord is disconnected, the internal cooling
fan stops operating. In this case, the lamp wilt be insufficiently
cooled and will take a while to turn ON again.
Auto shut off
To conserve lamp life, if there is no signal to the
set's tuner for 5 minutes, the lamp will shut off
automatically.
24
Loading ...
Loading ...
Loading ...