Loading ...
Loading ...
Loading ...
Page 8
INSTALLATION AND ASSEMBLY – Positioning
2. Allow for Ventilation
Your Sunstone™ grill is engineered with special vents on
the back of unit, which allow proper airflow out of the
back of grill, also increased airflow into Infra-red Burner
gas chamber. Be sure you allow a minimum of 4" behind
grill for proper air ventilation. Slide grill all the way into
cut-out, so there are no gaps present to inside of island
frame.
1. Slide Grill in Place
Your Sunstone™ grill is specially designed with an internal
built in hanger lip located at the Right, Left and Back sides.
The grill lip allows it to hang by the three supported edges
on the right, left and back. The front control panel requires
no supporting edge; it is designed to hang down the front of
your cut-out.
3. Securing in Place
The control panel is designed to sit flush against the island face. If counter top extends beyond the islands face,
creating a countertop overhang, it must be cut flush with the island face where the width of the control panel or a
gap will be created exposing the forward portions of the left and right side firewalls.
NOTICE: Ensure grill is installed with proper air flow for correct combustion air a nd cooling airflow.
Airflow MUST be maintained for the grill to perform as it was designed. If airflow is b locked,
overheating will occur and poor combustion will result. DO NOT INSTALL PLATFORM DIRECTLY UNDER
GRILL.
Loading ...
Loading ...
Loading ...