Loading ...
Loading ...
Loading ...
IMPORTANT: Table is coated with a protectant. To ensure
proper fit and operation, remove coating. Coating is easily
removed with mild solvents, such as mineral spirits, and a soft
cloth. Avoid getting solution on paint or any of the rubber or
plastic parts. Solvents may deteriorate these finishes. Use
soap and water on paint, plastic or rubber components. After
cleaning, cover all exposed surfaces with a light coating of oil.
Paste wax is recommended for table top.
WARNING; Never use highly volatile solvents. Non flamma-
ble solvents are recommended to avoid possibte fire hazard.
Refer to Figures 3-34.
CAUTION: Do not attempt assembly if parts are missing.
Use this manual to order replacement parts.
Be certain all parts are clean and free of shipping preserva-
tive. Also, completely remove all parts of packing. Saw cabinet
should be directly on the floor.
SAW INSTALLATION
Positioning the saw on a level surface will improve stability
and accuracy and prevent warpage and failure of cast
components and welds.
WARNING: Make certain that the saw is disconnected from
the power source.
INSTALL HANDWHEELS
Refer to Figure 3.
• Remove saw cabinet and place upside down on cardboard
box or cardboard on floor.
• Place one of the handwheels onto the blade raise!lower
shaft located on the front of the cabinet. Align the groove
in the back of the handwheel with the pin.
• Thread the washer and ]ocking knob onto the threaded end
of the shaft.
• Repeat the steps above to assemble the remaining hand-
wheel and locking knob onto the blade tilt shaft located on
the side of the cabinet.
Figure 4
ASSEMBLE MOBILE BASE PANELS
Refer to Figures 5 and 6, pages 6 and 7.
Tools Required: 4ram Hex Wrench
Hardware Required: Twenty-four M6 x 12 socket pan head
bolts (Hardware bag #4).
NOTE: Finger tighten bolts and nuts until caster sets are
assembled to base panels (Figure 12, page 7). Then tight-
en all fasteners securely.
• Attach the front panel between two corner supports using
six M6 x 12 socket pan head screws.
NOTE: Place the paneI edges INSIDE the corner support
surfaces.
NOTE: Front panel and rear panel are both stamped 'A'.
Front panel has warning label.
° Repeat above step for the rear panel
Letter Stamp On Top Edge
Figure 5....
• Turn all panels upside down to perform base assembly.
• Attach one corner of left panel (stamped 'B') to front panel
A.
-_ Attach the other corner of left panel B to rear panel A.
• Repeat above two steps for attachment of right panel
(stamped 'C').
REMOVE PACKING MATERIAL
Referto Figure4.
• Use the bladetilt handwheel to tilt the motorcompletelyto
45°.
• Removethe packing material from behindthe motor.
• Return motorto the 0° position.
6
Loading ...
Loading ...
Loading ...