Loading ...
Loading ...
Loading ...
Figure 26 - Check parallelism of rails to table with combination
square. Check at several locations along rail.
Loosen and remove six socket pan head screws and the
back panel, This will allow easier attachment of the rear rails.
Figure 27
• Install the rear rails in the same manner as the front rails
and align the rail joint to the blade,
• Replace back panel of the cabinet.
Figure 28
• Insert M8 x 20 hex bolts through holes in bracket at each
end of brace. Attach brace to the far right end of the rails
by sliding hex bolts into the railT-slots. Secure bolts in
position with fiat washers, lock washers and nuts.
i!:_i: , _ :
IiZZLIIL i:...........................ii ii :_ '_•
Figure 29
ATTACH SWITCH ASSEMBLY
Refer to Figure 30.
Tools Required: 10mm Open end Wrench
Hardware Required: Two M6 x I6 hex head bolts, two M6 flat
washers, two M6 lock washers and two M6 hex nuts.
(Hardware bag #3).
• From above switch assembly bracket, insert two bolts
through bracket holes.
° Loosely attach flat washer, lock washer and nut to bolts.
• Insert bolt heads into T-slot on bottom of left front rail.
• Slide switch assembly 6" to 8" from left end of rail as
shown in Figure 30.
• Fully tighten flat washers, lock washers and hex nuts to
secure switch assembly in place.
Figure 30
POSITION AND ADJUST RIVING KNIFE
Refer to Figure 31.
• Riving knife is installed on the saw. Raise the blade com-
pletely to access the riving knife.
° Loosen the locking knob and raise the riving knife to its
highest position. Riving knife has three holes for three posi-
tions. The highest position is for all thru cuts, The middle
position is for rabbets and other non-thru cuts, _(with guard
and pawls removed). The lowest position is for dado cuts.
Figure 31 - Riving Knife
Bracket
11
Loading ...
Loading ...
Loading ...