Loading ...
Loading ...
Loading ...
Page 9
3. Installer’s Guide
ATTENTION
• Ensure the tube is not bent or twisted.
• Ensure the tube is not in contact with the rear panel.
• The tube must be replaced before expiry date.
• The whole length of the tube must be checked.
• The maximum length of the exible rubber tube is 1200mm.
• Check all connections for gas leaks with soap and water. DO NOT use a naked
ame for detecting leaks.
B. The cooker can be connected with a Flexible Hose. The hose must be certied to AS/NZS 1869, 10mm ID,
class B or D, between 1 - 1.2m long and in accordance with AS/NZS 5601 for a high level connection. The hose
should not be subjected to abrasion, kinking or permanent deformation and should be able to be inspected
along its entire length. Unions compatible with the hose ttings must be used and connections tested for gas
leaks. The xed consumer piping outlet should be at approximately the same height as the cooker connection
point, pointing downwards. The hose should not touch the oor when the cooker is in the installed position.
Fix one end of the chain on the screw next to the gas inlet connection and the other end should be anchored
to the oor/wall so that the chain prevents strain on the hose connections when he cooker is pulled forward.
The appliance is factory set for Natural gas. The test point pressure should be adjusted to 1.00kPa with the
Wok burner operating at maximum.
The connection to the cooker should be on the same side of the point of feeding, in a way that the tube
doesn’t cross the back of appliance. If necessary, change the gas inlet or adapt the tube so that the entrance
of gas in the appliance is on the correct side.
Loading ...
Loading ...
Loading ...