Loading ...
Loading ...
Loading ...
Page 11
3. Installer’s Guide
To Fit The Stabilising Chains
In order to prevent tipping of the appliance it is equipped
with 2 chains for stabilising means and must be installed and
is required for safety reasons.
After the connection to gas and electrical supply is
completed and oven is located in its nal position. The
following MUST be done:
The 2 chains are tted in the upper part of the rear right and
the rear left side. These two chains enable the cooker to be
xed to the wall.
1. The anchor used to attach the chains to the rear wall
must be of a type suitable for the purpose.
2. If the appliance is installed between two cupboards, drill
a hole big enough on each side of the cupboards, to
allow the chains to pass through the holes and anchor
the chains within each cupboards.
3. If the appliance is installed next to drawers, remove
the drawers, then carry out the procedure described in
point 2. Ensure the anchor does not interfere with the
operation of the drawers. If the cooker is to be installed
next to an appliance, such as a dishwasher, temporarily
remove the appliance for access to t the stabilising
chains.
4. Make sure the xing to the wall is as close as possible
to the chain anchor point on the cooker and that the
chains are taught to effectively prevent the appliance
from tilting.
When the oven is moved for servicing, THE CHAINS MUST BE RE-ATTACHED by the technician.
Loading ...
Loading ...
Loading ...