Loading ...
Loading ...
Loading ...
Use & Installation Manual
38
Final Check List
To prevent improper connections leading to
damage of electrical components and so voiding
the warranty, the following steps must be
performed:
1. Check the electrical requirements and make
sure you have the correct electrical supply and
that the oven is properly grounded.
2. Turn on the power supply to the oven.
3. Check power at the junction box wires using a
voltmeter having a range of 0-250 VAC.
If you have installed the oven for use on 240
Volt supply, you should find that the voltage
reading between the black and red wires (Line
to Line) should be 220 to 240 Volts.
4. Set the clock by following these steps:
• Press [TIME] key twice until the display
shows “SET TIME”.
• Immediately press [INC] or DEC] keys to
set hours.
• Press [TIME] key again to change minutes.
• Immediately press [INC] or DEC] keys to
set minutes, hold to change by ten (10)
minutes step.
• Press [TIME] key or wait for a few seconds.
Clock is now set.
5. Test the bake mode by following this step:
• Move cooking mode knob to “BAKE”
position.
• Cooling fan, oven lights, preheat led will
turn on.
• A beep is sounded when the oven reaches
the preset
350 °F (175 °C) and the preheat light turn
off.
• Move the knob back to “OFF” position to
stop cooking.
6. To check the other oven functions refer to the
“Using the Oven Controls” section of the USE
AND CARE MANUAL.
7. If the oven is working properly, turn off the
power supply to the oven.
8. Place the cover on the junction box and make
sure the cover is securely fastened and turn
on the power to the oven.
Leave these INSTALLATION instructions as
well as the USE AND CARE MANUAL with the
owner.
Use & Installation Manual
38
ENGLISH
Loading ...
Loading ...