Loading ...
Loading ...
IMPORTANTINSTRUCTIONSFORYOURSAFETY
• All Ranges Can Tip
• Injury To Persons Could
Result
• Install Anti-tip Device
Packed With Range
• See Installation Instructions
Tools you will need:
Phillips head screwdriver
1 3/8" open end or adjustable wrench
fo Remove the bracket from the prepack
located inside the oven.
!. Decide whetherthe bracket will be installed
on the right or left side of range location.
3. If the bracket side of the range is adjacent
to a cabinet, place the bracket against
back wall and cabinet as shown below.
AOJACEN"
LOCATION OF RANGE SIDE
PANEL
OUTSIDE EDGE OF
0 BE
FLUSH WITH LEFT OR
RIGHT SIDE OF RANGE
N
WALL BEHIND
1
1
If there is no adjacent cabinet, determine
where the location of the range side (painted
outside panel) wil! be. Place the bracket
with its outside edge at this location and
against back wall. See illustration below.
Determine whether you will anchor the
bracket to the floor or wall. Make sure this
location is clear of electrical wiring or
plumbing.
Fasten the bracket securely with the screws
provided. Screws are self-drilling in wood,
plywood, particle and chip board, and
most meta! framing. If attaching to
masonry, you can buy suitable screws and
anchorsathardware stores. Useamasonry
drill to drill the required holes.
BRACKET
SCREW MUST ENTER X
WOOD OR METAL
WALL
PLATE
/
6. Using the wrench, back out the four leg
levelers at least two turns. See your
installation guide for more leveling
information before positioning range.
7. Sfide the range into place. Be sure rear leg
levelerfully engages the slot in the bracket. If
range cannot be moved back far enough
for rear leg leveler to enter bracket, move
bracket forward as required and attach to
floor in new location.
3 smportant safety instruction continued
Loading ...
Loading ...
Loading ...