Loading ...
Loading ...
Loading ...
Crank Rod
Assembly
joint
pin
Universaljoint
r
Bracket
TO INSTALL SHIFTER LEVER KNOB
• Thread the hex nut found in the parts bag
onto shifter lever.Thread the shifter lever
knob ontothe threaded end of the shifter
lever until it is snug against the hex nut
and the lip is pointed away from the en-
gine. "5ghten hex nut against the bottom
of the shifter lever knob. See figure below.
TO ASSEMBLE SNOW CHUTE
• Turn crank assembly counterclockwise
until it stops.
• Locate three carriage bolts,flatwashers
and nuts (found in parts bag) from snow
chute flange. DO NOT remove carriage
bolt over worm gear.
• Positionsnow chute on snow chute flange
and align the three holes in the snow
chute with holes inthe snow chute flange
as shown in figure below.
• Install carriage boltsfrom inside of chute
as shown in figure below, flatwashers and
nuts.
• "Nghtencarriage bolts securely, Be careful
not to overtighten. See figure below.
• Turn crank assembly clockwise and make
sure all carriage boltsare tight.
Locknut
Shifter Lever
NOTE: If the cables have become discon-
nected, reinstall spring as shown in figure
below. Clutch
Clutch Spring
Spring 4"Lg free ,/Boot
• Boot_ _t_te 3" Lgtree
Tractior
drive
spring
Tractic_
sprin!
Augerdrive
ing
,drive Aug_rdrive
lever springcable
Bolts
TO CHECK/ADJUST CLUTCH
CONTROL CABLES
The control cables attached to the auger
clutch lever and traction clutch lever as
shown in figure below may need to be ad-
justed before you use your snow thrower.
For instructionson checking or adjusting the
controlcables, (See To Adjust Clutch Control
Cables paragraph on page17).
actionClutchLever AugerClutchLever
0 ................... , --- ............... Z N
_ Controlcables
Loading ...
Loading ...
Loading ...