Loading ...
Loading ...
Loading ...
GENERAL RECOMMENDATIONS
The warranty on this snow thrower does not
cover items that have been subjected to op-
erator abuse or negligence. To receive full
value from the warranty, the operator must
maintain the snow thrower as instructed in
this manual. The maintenance chart is pro-
vided to assist the operator in properly
maintaining the snow thrower.
Some adjustments will need to be made pe-
riodically to properly maintain your snow
thrower.
AFTER FIRST USE
• Check for any loose or damaged parts.
• Tighten any loose fasteners.
• Check and maintain the auger.
• After each use, remove all snow and slush
off the snow thrower to prevent freezing of
auger or controls.
• Check controls to make sure they are
functioning properly.
• If any pads are worn or damaged, replace
immediately.
LUBRICATION CHART
Lubricate
DiscDrive
PlateZerk
witha Hi,
Temp
Moly
Grease.
SNOW THROWER
LUBRICATION - EVERY 25 HOURS
• LubricateDisc Drive Plateeverytwenty-five
(25) hours andat theend ofthe seasonand/
or before storage.
To Lubricate:
• Positionspeed selector lever in firstgear.
• Stand the snow thrower up on the auger
housing end.
• Remove the bottom panel (see second
figure on page 19 ).
Friction Shaft
Wheel Disc
(Requira
No
Lubdcalion)
Plate
Friction
Wheel Grease
\
Place cain in gap
between fdcUon
wheel and disc drive
U/plate
r-- ]
[_---Grease Zerk
r_grease
should be visible
• Turn disc drive plate clockwise by hand
untilgrease zerk is clearly visible at front
center. See figure below.
• Place a coin or (a shim of equal thick-
ness) between the rubber frictionwheel
and disc drive plate to
lion wheel contactingthe drive disc.
• To grease zerk, use a hand grease gun,
lubricatewith a Hi Temp EP Moly grease
See inset of second figure on this page.
DO NOT over fill or allow grease to come
in contact with the disc drive plate or fric-
tionwheel or damage willresult. Fill zerk
only untilgrease becomes visible below
bearing assembly located under grease
zerk. See insert in figure above.
IMPORTANT: Remove coinand ensure that
a gap exists between frictionwheel and disc
driveplate.
NOTE: Clean all excess grease found on
friction disc hub.
CAUTION: Do not allow grease to contact
friction wheel and disc drive plate.
15
Loading ...
Loading ...
Loading ...