Loading ...
Loading ...
Loading ...
The'operation of any snow thrower can re-
sult in foreign objects being thrown intothe
eyes, which can resuttin severe eye dam-
age. Always wear safety glasses or eye
shields while operating the snow thrower.
We recommend standard safety glasses or
a wide vision safety mask for over your
glasses, available at Craftsman Retail
• Stores or Service Centers.
/_ CAUTION: Read owner's manual
before operating machine. Never direct
discharge toward bystanders. Release the
auger controlbar and stop the engine
before uncloggingdischarge chute or auger
housing and before leaving the machine,
HOWTO USEYOUR SNOW
THROWER
TO<JTOP YOUR SNOW THROWER
• To stop throwing snow, release the auger
drive lever (see last figure on this page).
• To stop the wheels, release the traction
drive lever (see last figure on this page).
• To stop tbe'engine,_pushthe throttle con-
trel lever to off and pull out (DO NOT
TURN) the ignition key, see figure below.
button
Ignition
key,
TO MOVE FORWARD AND
BACKWARD
• To shift, release the traction drive lever
and move the speed shifter lever to the
speed you desire. Ground speed is deter-
mined by snow conditions. Select the
speed you desire by moving the speed
shifterlever into the appropriate area on
the speed selector.
Speeds 1, 2 - Wet, Heavy, Extra Deep
Speed 3 - Light
Speed 4 - Very Light
Speeds 5, 6 - Transport only
,' Engage the traction drive lever as shown
in figure below, lefthand. As the snow
thrower starts to move, maintain a firm
hold on the handles, and guide the snow
thrower along the clearing path. Do not at-
tempt to push the snow thrower.
• To move the snow thrower backward,
move the speed shifterlever into first or
second reverse and engage the traction
drive lever (lefthand).
IMPOR3"ANT: Never move the speed shifter
lever whilethe traction lever is down.
TOTHROW SNOW
• Push down the auger drive lever, see fig-
ure betow.
• Release to stop throwing snow.
TractionDriveLaver AugerDriveLever
control On
handle
Left hand Right hand
TO CONTROLSNOWDISCHARGE
• Turn the crank assembly to set the direc-
tion ofthe snow throwingo
• Loosen the wing knob on the chute de-
flector and move the deflector to set the
distance. Move the deflector (UP) for
more distance, (DOWN) for less distance.
Then tighten the wing knob, see figure
below.
knob
TO USE WHEEL LOCKOUT PiN
• The left hand wheel is secured to the axle
with a klickpin see figure below. This unit
was shipped with this klick pinin the
locked position (Idick pin through hole
in wheel).
Locked
Position
2-Wheel Odve
io
Loading ...
Loading ...
Loading ...