Loading ...
Loading ...
Loading ...
Troubleshooti
Cutting Problem
Workpiece strikes riving knife dur-
ing ripping
Workpiece binds, smokes, and
motor slows or stops when ripping
Possible Cause(s)
Riving knife not in line with blade
Saw blade out of alignment
Warped workpiece
Feed rate too fast
Carriage assembly loose
Fence not straight
Dull or incorrect blade
What to Do
Align riving knife to blade
Re-align
Do not cut severely warped pieces
Slow teed rate
Adjust carriage bearings, then
realign saw
Replace fence
Sharpen or replace blade
Board pulls away ti-om fence dur-
ing ripping
Saw blade out of alignment
May occur as normal result of
applying feed pressure
Re-align
Use featherboard on infeed side
Saw Problem
Radial arm moves when locked in
a non-indexed miter position
Motor moves v,,hen bevel lock is
locked
Yoke move:, when rip lock is
locked
Blade carriage does not travel
smoothly oil arm
Possible Cause(s)
Miter not locked firmly
Bevel not locked firmly
Rip lock not locked firmly
Dirty track
Carriage bearings set too tight
Rip lock rubbing track
Worn steel track
Bad carriage bearing
What to Do
Adjust miter lock for wear
Adjust bevel lock for wear
Adjust rip lock fl)r wear
Clean and lubricate track
Adjust carriage bearings, then re-
align saw
I*tosen Rip Dock
Replace track
Replace carriage bearing
Blade does not stop spinning with-
in 15 seconds after saw is turned
off
Blade nut loose
Internal damage
Tighten blade nut
Take saw back to Sears for service
68
Loading ...
Loading ...
Loading ...