Loading ...
Loading ...
Loading ...
Adjustments
Yoke Clamp Adjustment
lb check the yoke clamp adjustment follow
these steps:
1. Pull the yoke lock handle towards the
front of saw to unlock yoke. Pull forward on
the yoke index lever (on the left side of car-
riage) to disengage index pin.
2. Swivel the motor halfway between the
crosscutting and rip position so the index pin
is not engaged.
3. Lock the yoke lock handle.
4. Grasp the motor with both hands and try
to swivel it back into the crosscut position. It
should not move.
5. If it does move follow these steps:
a. Remo'_e arm cap.
b. Remove carriage stop screw and lock-
washer with a 1/4 inch hex-L wrench.
c. Grasp the carriage assembly, move it
carefully off the end of radial arm, hold-
ing it parallel to the radial arm until all
carriage bearings are free of their tracks.
d. Rest the motor and carriage assembly
on saw frame.
e. Set yoke lock handle at unlocked posi-
tion. Tighten nut with 15/16" wrench,
until lock handle locks mid-way betwecn
the two legs of the yoke.
f. Hold the motor and carriage assembly
parallel to radial arm and start the rear
bearings onto the tracks. Continue to hold
the assembly parallel to the tracks until
the forward bearings are on the tracks.
g. Slide the carriage rearward oil the radi-
al arm and install the carriage stop screw
and lockv;asher.
h. Install arm cap.
i. Repeat steps 1-4. Readjust if necess,rv.
/_ Yoke Lock Handle
Lock Washer
Arm Cap
Carriage Stop
Screw
Hex "L" Wrench
(1/4-Inch)
15i16"Wrench
2O
Loading ...
Loading ...
Loading ...