Loading ...
Loading ...
Loading ...
Accessories Safety
1. Use o1_y accessories listed in this section.
Use of any other accessory' or attachment
might increase the risk of injury to you or
others.
2. Read and follow instructions that come
with accessory.
3. Do not install accessories on both ends of
arbor shaft at same time.
4. Do not use twist drill bits longer than 7"
because they can bend and break.
5. Use a spade type drill 1" or smaller in
diameter for drilling only wood or plastic.
6. Do not use reduced shank drills.
7. Remove blade wrenches before turning
saw on,
_IkDANGER
Grinding wheels, abrasive or cut off
wheels, or wire wheels can break
explosively and throw pieces. You
can be blinded or receive a life
threatening puncture wound. Do
not use grind wheels, abrasive or
cut off wheels, or wire wheels.
WARNING
When using accessory shaft,
exposed arbor shaft can pull in
clothing, hair or jewelry as it
rotates. Broken bones and severe
cuts could occur.
Follow personal safety instructions.
Locate arbor shaft under radial arm:
lock blade carriage in out-rip posi-
tion, then bevel motor to -90 °.
Accessories
Information for Dado
1. Put inside loose collar on arbor shaft first,
then install dado. Tighten blade nut directly
against outside surface of dado.
2. Saw arbor is designed for dado up to
13/16" wide. Use of wider dado could cause
dado and blade nut to spin off. To make larg-
er than 13/16" wide cut, take several passes
with dado.
3. To avoid excessive load on motor when
making a 13/16" wide cut, limit depth of cut
to 1/8" in one pass.
Information for Edging
Edging is the use of a dado or molding head
in the horizontal position. Edging requires
the use of a molding head guard (see
Accessories List)
1. Use molding head guard for edging with
molding head and dado blade. Follow
instructions that come with guard. Do not
edge with a blade.
DANGER
Edging without a guard can bring
hands and fingers too close to
blade. Hands, fingers and arm could
be cut off. Buy, install, and follow
instructions for molding head
guard.
,_WARNING
Blade cannot be guarded in hori-
zontal position. Edge with guarded
molding head or dado. Do not edge
with blade.
2. Whenever possible, edge with arm locked
at indexed 0° miter, so blade carriage is
more likely to lock firmly.
3. Before edging, with saw unplugged and
yellow key out, turn cutting tool by hand to
make sure it does not strike guard or any
other part of saw.
6!
Loading ...
Loading ...
Loading ...