Loading ...
Loading ...
Loading ...
Assembly
Introduction
In order to get the most enjoyment out of your radial saw it is important that the machine by properly
assembled, adjusted, and aligned. This procedure, although not difficult, takes time; perhaps eight
hours or longer for the inexperienced user. However, after this initial set-up a weekly tune-up can be
completed in approximately ten minutes by checking the alignment and only adjusting those settings
which are incorrect.
Identify Parts
The following parts are included:
Note: Before beginning assembly, check that
all parts are included. If you are missing any
part, do not assemble the saw. Contact your
Sears Service Center to get the missing part.
Sometimes small parts can get lost in pack-
aging material. Do not throw away any
packaging until saw is put together. Check
packaging for missing parts be]ore contact-
ing Sears. A comptete parts list (Repair
Parts) is al the end of the manual. Use the
list to identify the number of the missing
part.
This model includes:
A. Basic Saw Assembly ......... 1
B. Rear "Fable .......................... 1
C. Spacer Table ...................... 1
D. Fence (wooden) ................. 1
E. Front [hble ........................ 1
F. Table Support .................... 2
G. Loose Parts Bag(s) ............ *
tt. Bag Containing
Accessory Guard ............... 1
J. Leg ..................................... 4
K. Stiffener, Side .................... 2
L. Stiffener, Front/Rear .......... 2
* Number varies; bags can contain other
smaller bags. Note: _lb make assembly easi-
er keep contents of each bag together and
separate from contents of other bags.
Remove protective
covering from arm trim
12
Loading ...
Loading ...
Loading ...