Loading ...
IMPORTANTSAFETYINFORMATION.
READALLINSTRUCTIONSBEFOREUSING.
WARNING!
For your safety, the information in this manual must be followed to minimize the risk of electric shock,
property damage or personal injury.
SAFETYPRECAUtiONS
_: Check and conq)ly with vour state and local
codes. You must fl)llow ti_ese guidelines.
::Ji::Use care when handling the water sotiening
s_:stem. Do not tm'n upside down, drop, drag
or set on sharp protrusions.
_: Water sotiening systems using sodimn chloride
(salt) for recharge add sodimn to the water.
Persons on sodium restricted diets should consider
the added sodium as part of their overall intake.
Potassium chloride can be used as an alternative
to sodium chloride in your softener
Tile _sater softening system _sorks on 24 _olt,60 Hz
electrical power only. Be sure to use onlythe
included transformer
_: Use clean water softening salts only, at least
99.5% pm'e. NUGGET, PEI,I,ET or coarse
SOLAR salts are recommended. Do not tlse rock,
block, granulated or ice cream making salts.
They contain dirt and sediments, or mush and
cake, and will create maintenance problems.
::Ji::Kee I) the salt hole cover in place on the softener
tmless servicing the trait or refilling with salt.
_, WARNING:Do.o, use with water that is
microbiologically tmsat_" or el unknown quality
without adequate disinfection beti)re or atier
tile system.
iJi::Transformer must be )luo,_ed into indoor
120 "_olt, grotmded outlet only.
PROPERINSTALLAtiON
This water softening system must be properly installed and located in accordance with the Installation
Instructions before it is used.
?_: Install or store where it will not be exposed to
temperatures beh)w fl'eezing or exposed to any
type of weather: Water fl'eezing in tile system will
break it. Do not attempt to treat water over I O0°E
::Ji::O0 n0tinstall in direct s/mlight, Excessive sun or
heat may catlse distortion or other damage to
non-metallic parts.
Properly ground to cent)tin with all governing
codes and ordinances.
Use only lead-free solder and flux for all sweat-
solder connections, as required by state and
federal codes.
_: Softener resins may degrade in tile presence
of chlorine above 1 ppm. If you have chlorine
in excess of this alnount, you inay experience
reduced life of tile resin. In these conditions,
you may wish to consider pro'chasing a (;E
i)oint-ofent_y household filtration system with
a chlorine reducing filte_:
A WARNING:Disc.,d.lluilusedpax'ts
and packaging material alter installation.
Small parts remaining after the installation
could be a choke hazard.
The water softening s}:stem requires a minimmn
water flow of three galhms per minute at the inlet.
Maximum allowable inlet water pressm'e is 125 psi.
]f daytime pressure is over 80 psi, nighttime
pressm'e may exceed the maximmn. Use a pressm'e
reducing wdve to reduce the flow if necessarx:
READANDFOLLOWTHISSAFETYINFORMAtiONCAREFULLY.
SAVETHESEINSTRUCTIONS
2
Loading ...
Loading ...
Loading ...