GE GXSF18G01 Water Softening System

Owner's Manual - Page 18

For GXSF18G01. Also, The document are for others GE - General Electric models: GXSF18G*

PDF File Manual, 64 pages, Read Online | Download pdf file

GXSF18G01 photo
Loading ...
Loading ...
Loading ...
About the water softener system.
Service: Manually Advance Recharge Check
NOTE:The control display must show a steady
time (not flashing).
I. Press the RECHARGE @ button and hold in
for three seconds. RECHARGEbegins to flash
as the water sottening system enters the fill
cycle of recharge. Remove the brinewell
cover and, using a flashlight, observe fill
water entering the brine tank. If water does
not enter tile tank, look tot an obstructed
nozzle, venturi, fill flow plug or brine tubing.
See Care and Cleaning of the Water Softener
System section.
2.After obser\ing fill, press tile RECHARGE @
button to move tile water softening s)_stem
into brining. A slow flow of water to the drain
will begin. Veritk' brine draw fl'om tile brine
tank by shining a flashlight into the brinewell
and observing a noticeable drop in the liquid
level over an extended period of time.
NOTE: Be sure a salt bridge is not preventing
water fl'om contacting salt. See Care and
cleaning of the water softening system section.
ff the water softening system does not draw brine,
check:
i_i' nozzle and/or venttlri dirty or deti_ctive.
N defective nozzle and venturi seal.
_: nozzle and venturi not seated propedy
on gasket.
_: other inner wive defect (rotor seal, rotor
and disc, wave washe_; etc.).
::Ji::restricted drain (check drain fitting and
hose).
NOTE:If water system pressure is low, an
elew_ted drain hose may cause back pressure,
stopping brine draw.
3.Again, press tile RECHARGE @ button to moxe
the water sottening system into backwash.
I,ook for a fast flow of water fl'om tile drain
hose. A slow flow indicates a i)lugged top
distributor, backwash flow plug or drain hose.
4. Press tile RECHARGE@ button to Inove tile
water sottening s):stem into tast rinse. Again
look for a tast drain flow. Allow the water
sottening system to rinse for a few minutes
to flush out any brine that mav remain in
the resin tank fl'om the brining cycle test.
5. To return tile water sottening system to
set\ice, press tile RECHARGE @ button.
18
Loading ...
Loading ...
Loading ...