GE - General Electric GXSF18G01 Owner's Manual

Loading ...

Step-by-step installation instructions.

Programming the Control (cont.)

SET SALTLEVEL _ _j]

I. Press the MODE button until

arrow I_ points to SALT LEVEL.

_] SALT LEVEL

2. Determine level of salt in brine tank using yellow

indicator on side of brine well, inside bcine tank

(see illustration on page 5).

3. Press UP • or DOX4N • .... I ] _" I_ SALTLEVEL

..... -C'I

button to set the SALT LEVEL

to correspond to lexel on

yellow indicator in brine tank.

NOTE:Each press of a button changes tile level bv

increments of 0.5 up to 8.0. (The GXSFI 8 salt level

maxim um is 5. Setting the control over 5 will result in the

unit running out of salt befi)re low salt indicator comes on.)

As the number increases, the salt level bax_ increase on

each whole number. I,owering the salt level below zero

tHx'xls tile SALTLEVELindicator OFE

4. Press tile MODEbutton to accept. _%_ 2" r'l

Tile displa) shows tile present time of _,_o_U

;'7

day and DAYSTOEMPTY.RECHARGE _

TONIGHTmayappear it unit is new. _ ...............

DAYS TOEMPTY _-_._nl

u [

Tile words DAYSTOEMPTYand a number - -

[

are shown in tile lower half of tile display. /

This information is shown in the normal

mn displa> This is to intorm the user of the xluxnbex"of days

betore the salt level in the brine tank reaches I,evel 0.

There will be salt lett in the salt tank, but it mav not be

sutticient to flflly recharge the system. Salt should be added

at this time to avoid hard water. The wflue is updated daily

and whenever tile SALTLEVELwflue is changed.

NOTE: Fox" the first several weeks of operation, the DAYS TO

EMPTY may provide erratic operation. Fox" example, tile

blue indicator light may flash, showing that more salt is

required, when the actual salt level in the tank is well above

the I,evel 0. In some cases, the DAYS TO EMPTYmav even

increase over a several week period.

It takes a couple of months for the water softener to learn

y0ur water usage pattern. Once it does this, it will accurately

determine actual salt usage pattern. During this period,

check salt level when blue indicator light flashes. If the salt

level in the tank is at I,evel 1 or above, allow system to xun.

Be sure to reset w)ur salt level indicator each time you add

salt to the system.

Loading ...

GE GXSF18G01 Water Softening System

Owner's Manual - Page 10